If you are angry with your newly purchased induction cooker then you need not worry anymore as I have made the solution available to you. If in case your device or induction cooking machine is not working or working properly or if the quality of the food is insufficient, then you can continue reading the article. If this article cannot solve your problem, please contact the service center of your respective brands or the Consumer Service Center in your country.
Now you can go with the different problems that can occur on your machine to which the solution has been given.
1. When the power button does not respond to the power on/off command, it means there is a connection problem. Please check whether the induction cooker is connected to the mains and whether the plug is firmly inserted into the wall outlet or not.
2. When the appliance beeps continuously and suddenly stops working, it happens when inappropriate cookware is kept on the cooktop or the cookware has been removed from the cooktop during cooking. Make sure the cookware is made of steel, iron or aluminum with a stainless steel lining base with a diameter greater than 12 cm.
GOLD
You placed the pan outside the cooking zone.
3. When the cookware does not heat up to the required temperature, this situation arises when the bottom of the cookware is not flat. Therefore, use flat-bottomed cookware. If the problem persists, consult your brand dealer or your authorized service center.
4. When the appliance is not changing from one preset mode to another, in this case, turn off the machine and restart it with another cooking mode.
5. When the cooking temperature of preset modes is too high or too low, in such case, please switch to manual mode for better temperature control. You can even adjust the cooking temperature in the following modes: – manual, roti/dosa, sauté and pressure cook.
6. After pressing one of the cooking mode buttons, the light of the selected mode does not light up, in this case, the light is faulty. Consult the distributor of your brand or your authorized service center.
7. When the cooking temperature changes automatically in some preset modes, the cooking temperature changes automatically in sauce mode only. For better control over the temperature switch to manual mode.
8. If the fan starts running without turning on the appliance, press a cooking mode button after you have pressed the center (on/off) button. If you do not press any of the cooking style buttons within one minute, the induction cooker will turn off and the fan will continue to run for a while to cool down the machine.
Error codes and their meanings
- E1 or E2: The primary sensor is in a short-circuit or open-circuit state. Consult the distributor of your brand or your authorized service center.
- E3 or E4: When this error code is displayed on the screen, it means that the heat sink sensor is in the state of short circuit or open circuit. Consult your brand distributor or your authorized service center.
- E5 or E6: The voltage is sometimes too low or too high. Wait for the voltage to stabilize and try again.
- E7: The fan is malfunctioning. Consult the distributor of your brand or your authorized service center.
- E8: The primary sensor is not working. Consult your brand distributor or your authorized service center.
- E9: The fuse has failed. Ask the distributor of your brand or your technical service center.
I hope this article solves your problem.