If you want to make a leather notebook cover, you are on the right page. In this article, we are going to share with you a DIY guide that will help you make a leather notebook cover. This can be an ideal gift for your loved ones. Without further ado, let’s look at the steps involved in the process. Keep reading to know more.
Things you need:
- Small notebook
- Leather needle
- Non-stick pressure foot
- Nylon Upholstery Thread
- Two-sided tape
- Glue
- Steel ruler
- Utility knife
- Fine leather
Step 1: cut the necessary parts
You need to cut the piece of leather into two different sizes to make the notebook cover. You need the following parts:
- 2 pieces of pen tabs measuring 2 ″ x 1 ″
- 1 piece of cardboard measuring 4 “x 2.25”
- 2 pieces of lapel measuring 6 ″ x 3 ″
- 1 piece of deck measuring 8.5 ″ x 6 ″
Step 2: Skive the pencil tabs
This process involves thinning a piece of leather to stack layers of leather on top of one another. Use your skiver to separate a thin layer from the back of each pen tab. Your goal should be to make the leather 50% thinner.
Step 3: attach the card pocket
You can separate a small notch from the card pocket with your utility knife. Alternatively, you can use a corner rounding tool. This tool can be used to round the bottom two corners to your personal preference.
Step 4: make a notch in the lapels
This step involves cutting the notches for the flaps. All you need to do is use your utility knife to cut a deep notch that measures 1/4 ″. Next, you need to mark this point. You can use a hard object such as a nail or pin to do this. During this process, each cut must be straight.
Step 5: prepare the cover for sewing
Now you should apply a little leather glue to the back of each hand. Let the glue dry for a few minutes. To make loops, you may want to move the tabs. You can also use a paper clip on the spot.
The next step is to place the flaps on the cover with the notches on the outside of the cover. You may want to mark the flap stop points.
Step 6: assemble everything
The last step was to assemble everything. Once you’ve assembled everything, the book is ready to go. You can then insert your pen into the strong loops to keep the lid closed. For additional details, it is a good idea to use metal stamps.
Simply put, if you want to make a leather book cover, we suggest that you follow the five steps explained in this article. This will make it much easier for you to go through the entire process. Hopefully, this DIY guide will help you through the entire process.